Charm Assembly Guide
Build your own charm necklace or bracelet
Seven steps, a pair of pliers in each hand, and your favorite charms. Lay everything out first, then work through the steps in order. If you get stuck on any of them, ask us.
-
Lay out your design
Arrange your charms on the table before you open a single ring. We suggest putting the heaviest piece in the center.
For necklaces, keep the charms lower on the chain so they all show in the front when you wear it.
-
Open the jump ring
Hold one plier vertically so it grips half of the jump ring. Use the other plier to pull the other half forward until the ring opens.
-
Open and ready
This is how the charm should look open.
-
Start in the center
NecklacesBegin with your center charm so the spacing comes out right.
BraceletsStart on either end or in the middle.
-
Add your charm
Clamp the bottom of the jump ring and slide one end through the hole in your charm.
-
Close the ring
With the chain and charm inside, use your other plier to hold one side of the jump ring steady. Push the right side backwards until it closes.
-
Check and repeat
Check the alignment, then repeat for the rest of your charms. Some people count the links between charms so the spacing stays even.
Final tips and reminders
- Start with the center charm so everything is centered when you wear your necklace.
- Heavier charms look great in the center.
- When in doubt, use a larger size jump ring.
- Attach your clasp using a jump ring.
- Don't be afraid to ask for help.
Have fun!